How To Change Wiper Blades On Fj Cruiser

How to change wiper blades on your Toyota FJ Cruiser

Toyota 's FJ Cruiser is unusual in that it has iii windscreen wipers. The blades are easy to alter once you lot know to remove them, and require no special tools. Let us show you how.

Published: 9 December 2019, 12:49

Toyota's FJ Cruiser has been on the market place hither since 2011. Information technology's one of the most funky models in Toyota's entire range and yet sells steadily, if not in serious volume.

There are some unique aspects to the FJ that have been compromised for the big off-roader'due south chop-topped wait. One of them is that you have to open the front doors kickoff before the back doors can exist opened. The other is that, because of the low roof line and wide windscreen, the FJ Cruiser uses three wipers to become the chore done!

Related: Nosotros review the Toyota FJ Cruiser

Let'due south check out those 3 wiper blades.

The 3 wiper blades are attached to simple arms, and there are no complex catches to remove or install them. What you need to know starting out is how they are fastened to the artillery, or you may try to remove them incorrectly and damage the arms.

When do I need to alter wiper blades?

When your wiper blades kickoff making streaks on your windscreen, the fourth dimension is ripe to replace. They may also start juddering or squeaking when they are operated. You may similar to get this done by a Toyota workshop, but it'southward a unproblematic 20 minute job once you know how to do information technology, and information technology requires no tools, so doing information technology yourself can save workshop labour costs. Measuring the blades and taking a picture of them will ensure you buy the right replacement blades. Remember, there are three of them!

Related: Our list of ten Best iv 10 4s

Step by step guide to replacing the FJ Cruiser'due south wiper blades

1. Kickoff with the nearest blade to the driver'due south door, past flipping the wiper arm upwards.

two. With the wiper arm extended abroad from the screen, swivel the blade so it is at a right angle to the arm.

three.Accept hold of the arm with your left mitt, and insert your right-hand'southward fingers between the safe and the blade frame.

4. Holding the wiper arm firmly with your left hand, yous now begin pushing the bract frame back towards the arm, and out of the arm's u-shaped claw. There are no catch releases to operate. The bract is merely kept in place by the housing that slides over the hook.

5. Keep pushing, until the blade'due south swivel pin is free of the wiper arm hook at the end of the arm.

vi. The old bract is now costless of the arm, and the new one can exist installed.

7. Refit the new blade (the old one is shown hither for illustration purposes) by pushing the hinge pin and its housing down the arm, towards the u-end of the arm claw. Yous must button it all the mode to the bottom end of the claw.

8. Swivel the blade back into its natural position, checking that it moves freely. Now, lower the arm and the blade dorsum on the screen. Operate the wiper switch inside the car to cheque that it is working properly. Use the aforementioned procedure to replace all three blades.